Winners will be notified by certified mail on official letterhead. (III) Giveaway winner(s) chosen by random drawing. Employees and agents of Publishers’ Development Corp. (II) Limit one (1) entry per household multiple entries will disqualify entrants. Deployed military should use stateside address. Mail-in entries accepted send postcards (no envelopes) to: GUNS Magazine, GOM December 2022, P.O. All entries must be received by giveaway end date. Factory warranties may apply in some cases. Giveaway prizes may have evidence of being test fired or exhibit minor handling marks. Associated taxes and fees are the responsibility of winners. No substitutions or transfers to third parties allowed. Prizes will not be awarded if illegal in jurisdiction of winners. (IV) Winners must undergo a background check (if required) and comply with all other federal, state and local laws. To protect the privacy and security of winners, names will not be made public. Winners must respond within 30 days of receiving notification or an alternate winner will be selected. Mail-in entries accepted send postcards (no envelopes) to: GUNS Magazine, GOM Old West 2023, PO Box 488, Escondido, CA 92033. I load them over 3.0 grains of Bullseye or Titegroup and they shoot beautifully from my conversion. 38 Long Colt ammo loaded with smokeless powder and hollow-base bullets (Speer 148-gr. That said I have over 500 rounds of good. When shooting black powder these are lubed with black powder-friendly SPG. RN from a now out-of-business manufacturer. I do have a hollow-base bullet mold for a 150-gr. Commercially made bullets cast of a soft alloy are available from Buffalo Arms of Sandpoint, Idaho. In past years hollow-base bullet molds were not hard to find. 38 Long Colt revolver you wish to shoot is an original or a facsimile such as my “modern” conversion, then the best choice is a 145–155-grain soft lead, hollow-base bullet. A charge of 2.7 to 3.0 grains of Bullseye will duplicate original factory ballistics (about 760–770 fps). 357/.358 solid-base, lead alloy bullets weighing 145 to 155 grains loaded normally. 1 Rule is this: if the revolver you are shooting is a. 375″ barrel with any sort of accuracy? The trick was to make them very soft and give them a deep hollow base. 38 Colt revolvers were no longer produced. Colt didn’t stop the practice with the SAA/Peacemaker until 1914 and by then its other. The barrels were still being made with nominal. 38 Colt cases were lengthened to 1.03″ and the 150-gr.
0 kommentar(er)
